Before you configure your 4-20mA sensor bridge settings online, make sure you have properly installed your sensor bridge.
Configuration:
Sign in to my.senseware.co to configure your sensor bridge. You can configure the bridge under the module configuration tab; the minimum (value at 4mA) and maximum (value at 20mA) conversion factors for each sensor can also be configured in this tab.
On the module configuration tab, you can change how often the sensor bridge samples data from the sensor. When the Node collects data from the sensor, the sensor bridge reports the average value of the readings.
When the bridge is connected to a Node on battery, the sampling frequency is automatically set to 'Collect when data is polled' to optimize battery life.
The data is directly available via data forwards or the Senseware dashboard. You can also remotely reset the sensor bridge in the system status by clicking on the 'Reset' button and selecting either 'Soft Reset' or 'Hard Reset.' A soft reset will restart the sensor and a hard reset will erase the saved configuration.