The volt sensor bridge has four connectors that can be used to monitor up to four sensors with 0-5V output.

Installation:

For each sensor, connect the two wires to one of the connectors as depicted below. The sensor bridge will measure the signal going through each of its connectors. 

Once the volt sensor bridge is properly wired, connect it to an available port on the node and power the node.

Click here to read more on how to configure your volt sensor bridge on the web.

Technical Specifications:

Power: 3.3V DC from node or gateway via micro-USB connector
Inputs: 4 x 0-5V signals
Bridge Output: 4 x 0-5V values (average over the sampling period)
Size (inches): 2.1 x 2.1 x 0.4
Weight (ounces): 0.8

Did this answer your question?