Dent PowerScout 24
How to connect Senseware to a Dent PowerScout 24 Meter
Julien Stamatakis avatar
Written by Julien Stamatakis
Updated over a week ago

You can use a Senseware Modbus Bridge to connect to the Dent PowerScout 24. Here is how:

1. Connect the 3 RS-485 wires of the PowerScout meter to the Modbus Sensor Bridge

2. Configure the registers you want to read from the Modbus Configuration page. 

3. Simply create your tiles on the Dashboard based on the data you are collecting from the meter.

Did this answer your question?