Connect wires to the 3rd party sensor, ensuring you have enough length to reach from the sensor installation location to the Attune Kit installation location

Remove the lid from the Kit

Feed the wires through the cable gland (1 in Figure 1) and tighten the gland to create a seal

Land the signal wires on one of the inputs on the Attune Bridge (2 in Figure 1). See this collection for more details on specifics for each bridge type

The 3rd party sensor may require power. If this is the case, land the power wire on the distribution block labelled with the voltage required (typically 24VDC, 12VDC, or 5VDC) for the sensor (3 in Figure 1).

Replace the lid on the Kit

Name your Bridge inputs and set signal bounds in the Module Configuration tab in the installation