Skip to main content

Refrigerant Leak Kit Installation

This article outlines all of the steps to connect and configure the Attune Refrigerant Leak Kit

N
Written by Nick Ahern
Updated over 2 months ago

Figure 1. Refrigerant Leak Sensor (left) and Attune Hardware (right)

Installation

  1. Sensor

    1. Install the sensor close to or inside an HVAC appliance where a leak could potentially occur

    2. Connect sensor cable from Attune Hardware

  2. Attune Hardware

    1. Mount to wall via included mounting backplate or command strips™

    2. Plug in power cord to standard wall outlet

Configuration

  1. Find the Attune Hardware Node on the via the Node ID in the System Status page

  2. Select the Node icon and navigate to the Module Configuration page

  3. Recreate the modbus read settings shown below

    1. Note: The multiplier will change based on the Gas and desired output units. Please reference Table 1 for the multiplier you should use

Table 1. Multipler Options

If any question arise feel free to contact Attune through the chat feature in the bottom right of the page

Did this answer your question?